Arendtsville soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 52 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Arendtsville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Arendtsville spot on the map
Rated from the USDA soil survey record for Arendtsville gravelly silt loam, 0 to 3 percent slopes (Lehigh County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 42 in (107 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 34% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly silt loam layer about 0 to 10 in down: about 18% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Loamy layerH2best layer A gravelly silty clay loam layer about 10 to 52 in down: about 28% clay, moderate plasticity when wet, dark red when moist. Possible
- Sandy layerH3 A very gravelly loam layer about 52 to 81 in down: about 18% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 52 in down in the typical profile: dark red (2.5YR 3/6); friable, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from red fanglomerate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 85 in (216 cm) down.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Pennsylvania, in these survey areas: Bucks County, Pennsylvania; Lehigh County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: South central Pennsylvania and New Jersey. The series is of small extent.
USDA, geographic setting: Gentle sloping to steep dissected uplands. Slopes are mainly 5 to 20 percent with an extreme range of about 2 to 40 percent. Arendtsville soils formed in materials weathered from a fanglomerate of quartzite, sandstone, aporhyolite, and other rocks held together in a red sandy matrix. The climate is humid and temperate. Mean annual precipitation ranges from 40 to 44 inches; mean annual temperature ranges 50 to 55 degrees F.; and the frost free season ranges from 165 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bowmansville: Promising
- Croton: Promising
- Mount Lucas: Promising
- Readington: Promising
- Towhee: Promising
- Amwell: Promising
- Brinkerton: Promising
- Cokesbury: Promising
See it on the map
Open a Arendtsville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Arendtsville gravelly silt loam, 0 to 3 percent slopes, map unit ArA in Lehigh County, Pennsylvania.
- Official Series Description: Arendtsville(revised 10/2003), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.