Annapolis soil
Wild-clay potential
Weak indication
Weak indication: no layer of Annapolis shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Annapolis soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Annapolis spot on the map
Rated from the USDA soil survey record for Annapolis fine sandy loam, 15 to 25 percent slopes (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 1% by volume).
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 11% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt A channery sandy clay loam layer about 8 to 27 in down: about 26% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Sandy layerE and Btbest layer A loamy sand layer about 27 to 61 in down: about 13% clay, low plasticity when wet. Weak indication
- Sandy layerCB A loamy sand layer about 61 to 81 in down: about 9% clay, low plasticity when wet, percent strong brown when moist. Weak indication
What it looks like raw
The sandy layer (E and Bt), 27 to 61 in down in the typical profile. Raw colour is not fired colour.
About the soil
- Parent material: glauconitic loamy fluviomarine deposits.
- USDA family mineralogy: glauconitic.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Charles County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal plain, upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lenni: Strong lead
- Magnolia: Strong lead
- Christiana: Strong lead
- Howell: Strong lead
- Elkton: Promising
- Liverpool: Promising
- Nanticoke: Promising
- Piccowaxen: Promising
See it on the map
Open a Annapolis spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 70%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Annapolis fine sandy loam, 15 to 25 percent slopes, map unit AnE in Charles County, Maryland.
- Official Series Description: Annapolis(revised 11/2015), established.
- Taxonomic class: Fine-loamy, glauconitic, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.