Alton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Alton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Alton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Alton gravelly loam, 3 to 8 percent slopes (Venango County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (1.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 30 in (77 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Lowers the potential High rock content (about 43% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A gravelly loam layer about 0 to 7 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBwbest layer A very gravelly coarse sandy loam layer about 7 to 37 in down: about 7% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layer2C An extremely gravelly coarse sand layer about 37 to 62 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (Bw), 7 to 37 in down in the typical profile: reddish brown (5YR 4/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly outwash and alluvium derived from sedimentary and metamorphic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Pennsylvania, in these survey areas: Venango County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Western, central and southern New York, and northern Pennsylvania. MLRA 101, 144A, and 140. The series is of large extent.
USDA, geographic setting: The Alton soils are on nearly level to very steep terraces, terrace faces, beach ridges, alluvial fans, and kames. They formed in glacial outwash and beach deposits dominated by acid, hard rock with material from limestone in the regolith below depths of 40 inches. In some places the substratum has silty lacustrine material below a depth of 40 inches. Slope ranges from 0 to 45 percent. Mean annual temperature ranges from 45 degrees to 50 degrees F., mean annual precipitation ranges from 28 to 46 inches, and the frost-free season ranges from 120 to 180 days. The elevation ranges from 250 to 1000 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cavode: Strong lead
- Ernest: Promising
- Wharton: Promising
- Alvira: Possible
- Atkins: Possible
- Cookport: Possible
- Frenchtown: Possible
- Gilpin: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Alton gravelly loam, 3 to 8 percent slopes, map unit AhB in Venango County, Pennsylvania.
- Official Series Description: Alton(revised 05/2011), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Dystric Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.