Yeljack soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 43 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Yeljack soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Yeljack spot on the map
Rated from the USDA soil survey record for Yeljack loam, 6 to 15 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A loam layer about 0 to 6 in down: about 20% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- TopsoilA12 A loam layer about 6 to 22 in down: about 20% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Loamy layerB1 A very fine sandy loam layer about 22 to 34 in down: about 18% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerB21t A sandy clay loam layer about 34 to 43 in down: about 31% clay, moderate plasticity when wet, dark red when moist. Promising
- Loamy layerB22tbest layer A sandy clay loam layer about 43 to 60 in down: about 31% clay, moderate plasticity when wet, dark red when moist. Promising
What it looks like raw
The loamy layer (B22t), 43 to 60 in down in the typical profile: dark red (2.5YR 3/6), red (2.5YR 4/6) dry; very hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and/or slope alluvium derived from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is inextensive.
USDA, geographic setting: Yeljack soils are at elevations of 6,500 to 8,500 feet. They occur on mountain slopes and broad mountain tops. Slopes are 6 to 30 percent. These soils formed in residuum and local alluvium from sandstone. The climate is humid and the average annual precipitation ranges from 25 to 35 inches. The mean annual temperature is 39 to 41 degrees F. The mean summer temperature is 50 to 55 degrees F., and the frost-free period ranges from 50 to 60 days. ASSOCIATED SOILS: These are the competing Ercan soils and the Charcol and Lucky Star soils. Charcol soils have more than 35 percent rock fragments in the control section. Lucky Star soils have mollic epipedons less than 20 inches thick and have...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Yeljack spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Yeljack loam, 6 to 15 percent slopes, map unit YeD in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Yeljack(revised 02/1999), established.
- Taxonomic class: Fine-loamy, mixed, superactive Pachic Palecryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.