Yad soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 14 to 25 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Yad soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Yad-Cranegulch-Duco complex, 4 to 15 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Btss2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (37): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 10.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A clay loam layer about 0 to 2 in down: about 31% clay, high plasticity when wet, brown when moist. Weak indication
- Loamy layerBA A clay loam layer about 2 to 6 in down: about 31% clay, high plasticity when wet, brown when moist. Possible
- Clay subsoilBtss1 A clay loam layer about 6 to 14 in down: about 37% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay subsoilBtss2best layer A clay layer about 14 to 25 in down: about 50% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay subsoil2Bt1 A clay loam layer about 25 to 41 in down: about 33% clay, high plasticity when wet, yellowish brown when moist. Promising
- Clay subsoil2Bt2 A gravelly sandy clay loam layer about 41 to 52 in down: about 30% clay, high plasticity when wet, yellowish brown when moist. Possible
- Clay subsoil2Bt3 A clay loam layer about 52 to 60 in down: about 33% clay, high plasticity when wet, light yellowish brown when moist. Possible
What it looks like raw
The clay subsoil (Btss2), 14 to 25 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; extremely hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium over loamy lacustrine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 10. Yad soils are of small extent.
USDA, geographic setting: Yad soil are on hill footslopes, summits, shoulders and backslopes, structural benches, butte escarpment footslopes and landslides at elevations of 2,650 to 4,350 feet. Slopes range from 4 to 35 percent. These soils formed in alluvium from lacustrine deposits over alluvium and colluvium from mixed lacustrine and igneous materials. The average annual precipitation is 14 to 18 inches. The average annual temperature is 47 to 50 degrees F. The frost-free period is 110 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Yad-Cranegulch-Duco complex, 4 to 15 percent slopes, map unit 6038 in Ada County, Idaho.
- Official Series Description: Yad(revised 06/2006), established.
- Taxonomic class: Fine, smectitic, mesic Chromic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.