Windmill soil
Wild-clay potential
Weak indication
Weak indication: no layer of Windmill shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Windmill soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Windmill spot on the map
Rated from the USDA soil survey record for Windmill gravelly loam, 6 to 10 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 30% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A gravelly loam layer about 0 to 4 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- TopsoilA12 A gravelly loam layer about 4 to 10 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerB2 A gravelly loam layer about 10 to 17 in down: about 20% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC1 A gravelly fine sandy loam layer about 17 to 23 in down: about 15% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC2 A very gravelly loamy very fine sand layer about 23 to 32 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC3&C4best layer A very gravelly loamy very fine sand layer about 32 to 60 in down: about 5% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (C3&C4), 32 to 60 in down in the typical profile: grayish brown (10YR 5/2), dark grayish brown (10YR 4/2) moist; loose, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits derived from limestone.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. These soils are inextensive.
USDA, geographic setting: Windmill soils occur on nearly level to steep, 1 to 20 percent, convex slopes of alluvial fans, off shore bars and dissected lake terraces at elevations of 4,300 to 5,200 feet. They formed in mixed alluvium and beach deposits, dominantly from limestone and some quartzite. The climate is dry subhumid. Mean annual temperature is about 47 to 49 degrees F. and mean summer temperature is about 67 to 70 degrees F. The average annual precipitation is 11 to 13 inches. The frost-free period is 100 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Windmill spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Windmill gravelly loam, 6 to 10 percent slopes, map unit WnD in Box Elder County, Utah, Eastern Part.
- Official Series Description: Windmill(revised 02/2004), established.
- Taxonomic class: Loamy-skeletal, carbonatic, mesic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.