Watson soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 27 to 45 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Watson soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Watson silt loam, 0 to 3 percent slopes (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (9.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts about 27 in (68 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 31% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 20% clay, moderate plasticity when wet, dark brown when moist. Possible
- Loamy layerH2 A gravelly silty clay loam layer about 9 to 27 in down: about 28% clay, moderate plasticity when wet, reddish yellow when moist. Possible
- Loamy layerH3best layer A gravelly clay loam layer about 27 to 45 in down: about 28% clay, moderate plasticity when wet, yellowish red when moist. Possible
- Loamy layerH4 A channery loam layer about 45 to 61 in down: about 20% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
What it looks like raw
The loamy layer (H3), 27 to 45 in down in the typical profile: yellowish red (5YR 5/6), gray (10YR 6/1); very firm, brittle, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: old till derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Glaciated portion of Ridge and Valley area in east central Pennsylvania. It is of moderate extent, with an estimated 25,000 acres.
USDA, geographic setting: These soils are mainly in the glaciated section of the Ridge and Valley area. The slopes are nearly level to moderately steep. Gradients are dominantly 3 to 8 percent but range from 0 to 20 percent. The soils formed in loamy pre-Wisconsin glacial till derived from sandstone, siltstone and shale similar to that of the underlying rock. The climate is humid temperate, mean annual precipitation ranges from 38 to 48 inches, mean annual air temperature ranges from 50 to 55 degrees F., the frost-free season ranges from 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Shelmadine: Promising
- Comly: Promising
- Holly: Promising
- Kedron: Promising
- Allenwood: Possible
- Alvira: Possible
- Meckesville: Possible
- Albrights: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Watson silt loam, 0 to 3 percent slopes, map unit WsA in Carbon County, Pennsylvania.
- Official Series Description: Watson(revised 07/2001), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.