Allenwood soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 11 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Allenwood soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Allenwood spot on the map
Rated from the USDA soil survey record for Allenwood gravelly loam and silt loam, 0 to 3 percent slopes (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 34% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (14).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 31% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly loam layer about 0 to 11 in down: about 18% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerH2best layer A gravelly silty clay loam layer about 11 to 36 in down: about 34% clay, moderate plasticity when wet, red when moist. Possible
- Loamy layerH3 A gravelly loam layer about 36 to 96 in down: about 20% clay, moderate plasticity when wet, red when moist. Weak indication
What it looks like raw
The loamy layer (H2), 11 to 36 in down in the typical profile: red (2.5YR 5/8); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: old till derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 16 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Lehigh County, Pennsylvania; Northampton County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Glaciated portion of Ridge and Valley physiographic province in east central Pennsylvania. The series is of moderate extent with an area of roughly 50,000 acres.
USDA, geographic setting: The Allenwood soils are on smooth or slightly convex uplands. Slopes are dominantly 3 to 8 percent but range from 2 to 25. The soils formed in loamy pre-Wisconsin glacial till derived from sandstone, siltstone and shale, similar to that of the underlying rock. The climate is humid temperate; mean annual precipitation ranges from 38 to 48 inches, mean annual air temperature ranges from 50 to 55 degrees F., and the frost free season ranges from 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Comly: Promising
- Holly: Promising
- Brinkerton: Promising
- Cokesbury: Promising
- Duffield: Promising
- Shelmadine: Promising
- Washington: Promising
- Bowmansville: Promising
See it on the map
Open a Allenwood spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Allenwood gravelly loam and silt loam, 0 to 3 percent slopes, map unit AdA in Carbon County, Pennsylvania.
- Official Series Description: Allenwood(revised 07/2001), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.