Washington soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 9 to 42 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Washington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Washington spot on the map
Rated from the USDA soil survey record for Washington silt loam, 0 to 3 percent slopes (Lehigh County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerH2best layer A clay loam layer about 9 to 42 in down: about 30% clay, moderate plasticity when wet, strong brown when moist. Promising
- Loamy layerH3 A gravelly loam layer about 42 to 61 in down: about 23% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- BedrockH4 Bedrock about 61 to 71 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 42 in down in the typical profile: strong brown (7.5YR 5/6); friable. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from limestone and/or old glacial drift.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 61 in (155 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Lehigh County, Pennsylvania; Northampton County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Northwest New Jersey and east-central Pennsylvania. The series is of large extent with about 122,000 acres identified.
USDA, geographic setting: Washington soils occur on nearly level to steep till plains within limestone valleys, commonly with many shallow, closed depressions. The soils formed in old glacial drift (pre-Wisconsin Age) or colluvium from these materials, typically overlying limestone bedrock. Mean annual air temperature ranges from 50 to 55 degrees F. and mean annual precipitation is about 40 to 48 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brinkerton: Promising
- Cokesbury: Promising
- Comly: Promising
- Duffield: Promising
- Holly: Promising
- Bowmansville: Promising
- Califon: Promising
- Croton: Promising
See it on the map
Open a Washington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Washington silt loam, 0 to 3 percent slopes, map unit WaA in Lehigh County, Pennsylvania.
- Official Series Description: Washington(revised 12/2005), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.