Warm Springs soil
Wild-clay potential
Weak indication
Weak indication: no layer of Warm Springs shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Warm Springs soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Warm Springs spot on the map
Rated from the USDA soil survey record for Warm Springs fine sandy loam, 0 to 1 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 11% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 37 in (94 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 19% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 8 in down: about 16% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2 A fine sandy loam layer about 8 to 15 in down: about 19% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerH3 A fine sandy loam layer about 15 to 24 in down: about 19% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerH4 A fine sandy loam layer about 24 to 37 in down: about 17% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerH5best layer A loamy fine sand layer about 37 to 60 in down: about 11% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (H5), 37 to 60 in down in the typical profile: light gray (2.5Y 7/2), light brownish gray (2.5Y 6/2) moist; hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah; Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah and western New Mexico. These soils are moderately extensive. The series concept and main acreage is in MLRA 28A in Utah. Warm Springs soils in New Mexico are in MLRA 36 (see Remarks section below).
USDA, geographic setting: Warm Springs soils are on low lake terraces. These soils formed in lacustrine deposits derived from mixed sedimentary and igneous rocks. Slopes are 0 to 3 percent. The climate is dry subhumid. The mean annual precipitation is 14 to 18 inches. The mean annual temperature is 45 to 52 degrees F., the mean summer temperature is 68 to 73 degrees F., and the frost-free period is 130 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Lasil: Strong lead
- Payson: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
See it on the map
Open a Warm Springs spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Warm Springs fine sandy loam, 0 to 1 percent slopes, map unit WaA in Davis-Weber Area, Utah.
- Official Series Description: Warm Springs(revised 11/2005), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Oxyaquic Calcixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.