Walpole soil
Wild-clay potential
Weak indication
Weak indication: no layer of Walpole shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Walpole soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Walpole spot on the map
Rated from the USDA soil survey record for Walpole silt loam (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 33% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 7 in down: about 4% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2 A gravelly fine sandy loam layer about 7 to 24 in down: about 4% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH3best layer A gravelly sand layer about 24 to 65 in down: about 1% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 24 to 65 in down in the typical profile: light brownish gray (10YR 6/2), few brown (10YR 5/3); loose. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly glaciofluvial deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maine, Vermont, in these survey areas: Addison County, Vermont; Somerset County, Maine, Southern Part.
By state: wild clay in Maine,wild clay in Vermont.
USDA, distribution and extent: Late Wisconsin glaciofluvial landforms in Connecticut, Massachusetts, New Hampshire, eastern New York, Rhode Island, and Vermont; MLRAs 101, 142, 144A, and 145. Walpole series has been correlated in some published surveys in Maine, but after conducting temperature studies, Maine currently includes only frigid and cryic soil temperature regimes. The series is of moderate extent.
USDA, geographic setting: Walpole soils are nearly level and gently sloping soils in shallow drainageways and low-lying areas on terraces and plains. Slope ranges from 0 to 8 percent. The soils formed in sandy glaciofluvial and stratified drift materials derived mainly from crystalline rocks. Mean annual temperature ranges from 7 to 12 degrees C., mean annual precipitation ranges from 940 to 1270 mm, and the growing season ranges from 120 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Melrose: Strong lead
- Biddeford: Strong lead
- Buxton: Strong lead
- Covington: Strong lead
- Lamoine: Strong lead
- Livingston: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
See it on the map
Open a Walpole spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Walpole silt loam, map unit Wa in Addison County, Vermont.
- Official Series Description: Walpole(revised 05/2014), established.
- Taxonomic class: Sandy, mixed, mesic Aeric Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.