Waldbillig soil
Wild-clay potential
Weak indication
Weak indication: no layer of Waldbillig shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Waldbillig soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Waldbillig spot on the map
Rated from the USDA soil survey record for Waldbillig-Holloway gravelly ashy silt loams, 8 to 30 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 41% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerBw A gravelly ashy silt loam layer about 2 to 12 in down: about 10% clay, low plasticity when wet, light brown when moist. Weak indication
- Sandy layer2E A very gravelly fine sandy loam layer about 12 to 28 in down: about 13% clay, low plasticity when wet, pink when moist. Weak indication
- Sandy layer2E and Btbest layer A very gravelly fine sandy loam layer about 28 to 60 in down: about 13% clay, low plasticity when wet, pink when moist. Weak indication
What it looks like raw
The sandy layer (2E and Bt), 28 to 60 in down in the typical profile: pink (5YR 7/3), reddish brown (5YR 5/3) moist; slightly hard, very friable, nonsticky and nonplastic; very hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alpine till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Waldbillig soils are of large extent in intermountain valleys of western Montana. MLRA 43A.
USDA, geographic setting: Landform- mountains and moraines.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Open a Waldbillig spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Waldbillig-Holloway gravelly ashy silt loams, 8 to 30 percent slopes, map unit 118 in Missoula County Area, Montana.
- Official Series Description: Waldbillig(revised 10/2008), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive Andic Haplocryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.