Greenough soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 24 to 51 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Greenough soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Greenough spot on the map
Rated from the USDA soil survey record for Greenough silt loam, 4 to 15 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 11% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerE A silt loam layer about 2 to 10 in down: about 13% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerE/Bt A silt loam layer about 10 to 24 in down: about 13% clay, low plasticity when wet, is light gray when moist. Weak indication
- Clay subsoilBt1best layer A silt loam layer about 24 to 51 in down: about 25% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Clay subsoilBt2 A gravelly silt loam layer about 51 to 60 in down: about 25% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 24 to 51 in down in the typical profile: light brownish gray (2.5Y 6/2), grayish brown (2.5Y 5/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: The Greenough soils are of moderate extent in western Montana.
USDA, geographic setting: Landform - stream terraces; hills.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Minesinger: Possible
- Alberton: Weak indication
- Bandy: Weak indication
See it on the map
Open a Greenough spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Greenough silt loam, 4 to 15 percent slopes, map unit 49 in Missoula County Area, Montana.
- Official Series Description: Greenough(revised 09/2002), established.
- Taxonomic class: Fine-silty, mixed, superactive, frigid Udic Haplustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.