Minesinger soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 13 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Minesinger soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Minesinger spot on the map
Rated from the USDA soil survey record for Minesinger-Bigarm complex, 0 to 4 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Lowers the potential High rock content (about 39% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 A gravelly loam layer about 0 to 6 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A cobbly loam layer about 6 to 13 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A very gravelly clay layer about 13 to 24 in down: about 43% clay, high plasticity when wet, pale brown when moist. Possible
- Loamy layerBk A very gravelly clay loam layer about 24 to 60 in down: about 34% clay, high plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 13 to 24 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 5/3) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: tertiary slope alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Minesinger soils are of small extent in intermountain valleys and foothills in western Montana. MLRA 43A, 44A and 46.
USDA, geographic setting: Landform- dissected alluvial fans, stream terraces, and hills.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Alberton: Weak indication
- Bandy: Weak indication
See it on the map
Open a Minesinger spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Minesinger-Bigarm complex, 0 to 4 percent slopes, map unit 7 in Missoula County Area, Montana.
- Official Series Description: Minesinger(revised 09/2008), established.
- Taxonomic class: Clayey-skeletal, mixed, superactive, frigid Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.