Alberton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Alberton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Alberton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Alberton spot on the map
Rated from the USDA soil survey record for Alberton very fine sandy loam, 0 to 2 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 12% by volume).
Layer by layer
- TopsoilAp A very fine sandy loam layer about 0 to 9 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA A sandy loam layer about 9 to 16 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw A sandy loam layer about 16 to 30 in down: about 12% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBCbest layer A loamy sand layer about 30 to 60 in down: about 8% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (BC), 30 to 60 in down in the typical profile: light brownish gray (10YR 6/2), grayish brown (10YR 5/2) moist; loose, nonsticky, and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Alberton soils are of small extent in valleys of western Montana.
USDA, geographic setting: Alberton soils are on terraces. Elevations are 2,800 to 3,500 feet. Slopes are 0 to 2 percent. These soils formed in alluvium. The climate is characterized by long, cold winters; moist springs; and warm, dry summers. Mean annual precipitation is 11 to 14 inches, much of which falls as show and as spring rain. Mean annual temperature is 43 to 45 degrees F. The frost-free period is 105 to 120 days. DRAINAGE AND PEREMABILITY: Somewhat excessively drained; slow runoff; moderately rapid permeability above 30 inches and rapid below.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Bandy: Weak indication
See it on the map
Open a Alberton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Alberton very fine sandy loam, 0 to 2 percent slopes, map unit 1 in Missoula County Area, Montana.
- Official Series Description: Alberton, established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Aridic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.