Crow soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 12 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Crow soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Crow silt loam, 4 to 15 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 38 in (97 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerE A silt loam layer about 2 to 6 in down: about 15% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Clay subsoilBt/E A silty clay loam layer about 6 to 12 in down: about 30% clay, moderate plasticity when wet, is yellowish brown when moist. Promising
- Clay subsoilBtbest layer A silty clay layer about 12 to 50 in down: about 50% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layerBC A sandy clay loam layer about 50 to 60 in down: about 28% clay, moderate plasticity when wet, very pale brown when moist. Possible
What it looks like raw
The clay subsoil (Bt), 12 to 50 in down in the typical profile: yellowish brown (10YR 5/4), brown (10YR 4/3) moist; very hard, very firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Crow soils are of small extent in western Montana.
USDA, geographic setting: Landform - alluvial fans; stream terraces; mountains; hills; glacial moraines.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
- Bandy: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Crow silt loam, 4 to 15 percent slopes, map unit 33 in Missoula County Area, Montana.
- Official Series Description: Crow(revised 05/2003), established.
- Taxonomic class: Fine, mixed, superactive, frigid Typic Haplustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.