Burnt Fork soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 18 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Burnt Fork soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Burnt Fork spot on the map
Rated from the USDA soil survey record for Burnt Fork loam, 0 to 4 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (13).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 8 in (21 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 10 in down: about 20% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerBwbest layer A loam layer about 10 to 18 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerBk1 A fine sandy loam layer about 18 to 24 in down: about 16% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBk2 A fine sandy loam layer about 24 to 41 in down: about 12% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBCk A very gravelly fine sandy loam layer about 41 to 60 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The loamy layer (Bw), 10 to 18 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; friable, hard, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Burnt Fork soils are of small extent in the intermountain valleys of southwest Montana. MLRA 44A.
USDA, geographic setting: Landform - fan remnants, eroded fan remnants, and escarpments
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
- Bandy: Weak indication
See it on the map
Open a Burnt Fork spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Burnt Fork loam, 0 to 4 percent slopes, map unit 100B in Missoula County Area, Montana.
- Official Series Description: Burnt Fork(revised 10/2012), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Typic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.