Transquaking soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 65 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Transquaking soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Transquaking spot on the map
Rated from the USDA soil survey record for Transquaking and Mispillion soils, 0 to 1 percent slopes, very frequently flooded, tidal (New Castle County, Delaware) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 42% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Lowers the potential Typically starts about 65 in (165 cm) down, deeper than most hand digging.
- Missing data Rock fragment content is not reported.
Layer by layer
- Organic top layerOise An organic top layer about 0 to 9 in down, not a clay body. Weak indication
- Organic top layerOese An organic top layer about 9 to 46 in down, not a clay body. Weak indication
- Organic top layerOase An organic top layer about 46 to 65 in down, not a clay body. Weak indication
- Clay-rich layerCsegbest layer A silty clay layer about 65 to 80 in down: about 42% clay, high plasticity when wet, very dark gray when moist. Promising
What it looks like raw
The clay-rich layer (Cseg), 65 to 80 in down in the typical profile: very dark gray (5Y 3/1); silty clay; friable; slightly sticky, slightly plastic; very fluid. Raw colour is not fired colour.
About the soil
- Parent material: herbaceous organic material over loamy estuarine deposits.
- USDA family particle-size class: not used.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Delaware, in these survey areas: New Castle County, Delaware.
By state: wild clay in Delaware.
USDA, distribution and extent: General Area--Tidal salt marshes of the mid-Atlantic coastal plain within the states of Maryland, Delaware, and New Jersey
USDA, geographic setting: Landscape--Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Talleyville: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Broadkill: Promising
- Delanco: Promising
- Elsinboro: Promising
- Glenelg: Promising
See it on the map
Open a Transquaking spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Transquaking and Mispillion soils, 0 to 1 percent slopes, very frequently flooded, tidal, map unit TP in New Castle County, Delaware.
- Official Series Description: Transquaking(revised 02/2025), established.
- Taxonomic class: Euic, mesic Typic Sulfihemists
- Rated with rule version 2026-09-28.1; the method is on the About page.