Tevis soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tevis shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tevis soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tevis gravelly loam, 30 to 60 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 36 in (91 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 67% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- TopsoilA A gravelly loam layer about 2 to 5 in down: about 13% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerE1 A very gravelly sandy loam layer about 5 to 16 in down: about 7% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerE2 An extremely gravelly sandy loam layer about 16 to 24 in down: about 7% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerE/Bwbest layer An extremely gravelly sandy loam layer about 24 to 60 in down: about 7% clay, low plasticity when wet, is very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (E/Bw), 24 to 60 in down in the typical profile: is very pale brown (10YR 7/3), brown (10YR 5/3) moist; which surrounds the B part; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from metasedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Tevis soils are of small extent in western Montana. MLRA 43A.
USDA, geographic setting: Landform - mountains.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tevis gravelly loam, 30 to 60 percent slopes, map unit 102 in Missoula County Area, Montana.
- Official Series Description: Tevis(revised 10/2008), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Dystric Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.