Tenmile soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 10 to 37 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tenmile soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tenmile spot on the map
Rated from the USDA soil survey record for Tenmile very gravelly loam, 0 to 4 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (28): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential High rock content (about 51% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A very gravelly loam layer about 0 to 10 in down: about 17% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoilBtbest layer A very gravelly clay loam layer about 10 to 37 in down: about 35% clay, high plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerBC A very gravelly sandy clay loam layer about 37 to 49 in down: about 33% clay, high plasticity when wet, brownish yellow when moist. Weak indication
- Sandy layer2C A very gravelly loamy coarse sand layer about 49 to 60 in down: about 5% clay, low plasticity when wet. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 37 in down in the typical profile: light yellowish brown (10YR 6/4), dark brown (10YR 3/3) moist; hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: sandy alluvium derived from granite and/or volcanic rock.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. These soils are moderately extensive.
USDA, geographic setting: Tenmile soils are on dissected alluvial terraces. Elevation ranges from 2,700 to 4,500 feet. Slopes are 0 to 65 percent. The soils formed in coarse mixed alluvium with a slight influence of loess. Average annual precipitation ranges from 10 to 14 inches. Average January temperature is about 27 degrees F, average July temperature is about 71 degrees F, and the average annual temperature is 49 to 55 degrees F. Frost-free period is 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Tenmile spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tenmile very gravelly loam, 0 to 4 percent slopes, map unit 174 in Ada County, Idaho.
- Official Series Description: Tenmile(revised 05/2001), established.
- Taxonomic class: Clayey-skeletal, smectitic, mesic Xeric Haplargids
- Rated with rule version 2026-09-28.1; the method is on the About page.