Tally soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tally shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tally soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tally variant sandy loam, 0 to 4 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 26% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A sandy loam layer about 0 to 10 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBw A sandy loam layer about 10 to 20 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerC1 A loamy sand layer about 20 to 30 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC2best layer A gravelly sand layer about 30 to 60 in down: about 3% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 30 to 60 in down in the typical profile: light yellowish brown (2.5Y 6/4), light olive brown (2.5Y 5/4) moist; slightly hard, friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: sandy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: In the valleys of western Montana and on the plains of eastern Montana and adjacent areas in North Dakota, South Dakota, and possibly northeastern Wyoming. It is an extensive series.
USDA, geographic setting: Landform - alluvial fans; stream terraces; till plains; drainageways; hills; sedimentary plains; outwash plains. Elevation - 1,800 to 5,000 feet. (In Wyoming and Utah it ranges to 8,200 feet; South Dakota ranges down to 1,000 feet) Slope- 0 to 45 percent. Parent material - eolian material or alluvium and glaciofluvial deposits derived from quartzite, granite, sandstone, or limestone rock sources. Climate - cool, with cold, dry winters; moist springs; warm summers. Mean annual precipitation - 12 to 20 inches, most of which falls in spring and early in summer. Rainfall areas of less than 14 inches are cooler and have lower evaporation. Mean annual air temperature - 39 to 45 degrees F....
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tally variant sandy loam, 0 to 4 percent slopes, map unit 101 in Missoula County Area, Montana.
- Official Series Description: Tally, established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Typic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.