Tadpole soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tadpole shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tadpole soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tadpole spot on the map
Rated from the USDA soil survey record for Tadpole silt loam, saline, 0 to 2 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 23 in (59 cm)).
- Lowers the potential Typically starts about 49 in (124 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 10% by volume).
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A silt loam layer about 0 to 2 in down: about 14% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- TopsoilA2 A silt loam layer about 2 to 10 in down: about 15% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerBk A silt loam layer about 10 to 13 in down: about 17% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerBkq A very paragravelly silt loam layer about 13 to 23 in down: about 14% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerBknq1 A silt loam layer about 23 to 32 in down: about 14% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerBknq2 A silt loam layer about 32 to 37 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layer2C1 A loam layer about 37 to 49 in down: about 7% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layer2C2best layer A loamy fine sand layer about 49 to 72 in down: about 5% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (2C2), 49 to 72 in down in the typical profile: pale brown (10YR 6/3), yellowish brown (10YR 5/4) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and/or weathered volcanic ash over coarse-loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Ada and Elmore Counties, Idaho; MLRA 11. These soils are of limited extent.
USDA, geographic setting: Tadpole soils are on plug domes, pressure ridges, lava flow lobes and troughs on shield volcanoes of plains. Elevations are 2,800 to 3,550 feet. Slopes range from 0 to 20 percent. These soils formed in loess and weathered volcanic ash over coarse-loamy alluvium from basalt and volcanic ash. Average annual precipitation is 6 to 8 inches. Average annual temperature is 51 to 54 degrees F. Frost-free period is 130 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Tadpole spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tadpole silt loam, saline, 0 to 2 percent slopes, map unit 4003 in Ada County, Idaho.
- Official Series Description: Tadpole(revised 07/2012), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Durinodic Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.