Syracuse soil
Wild-clay potential
Weak indication
Weak indication: no layer of Syracuse shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Syracuse soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Syracuse spot on the map
Rated from the USDA soil survey record for Syracuse loamy fine sand, 0 to 2 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A loamy fine sand layer about 0 to 11 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAC A sandy loam layer about 11 to 21 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC1ca A sandy loam layer about 21 to 30 in down: about 12% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerC2cabest layer A sandy loam layer about 30 to 60 in down: about 14% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C2ca), 30 to 60 in down in the typical profile: very pale brown (10YR 8/2), light gray (10YR 7/2) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 8,500 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Syracuse soils are on low lake terraces. These soils have formed in moderately coarse textured alluvium and lake sediments that are derived mainly from quartzite, limestone, and gneiss, but include material from many other kinds of rocks. Slopes are 0 to 3 percent. Elevations range from 4,200 to 4,600 feet. The climate is dry subhumid. The mean annual precipitation is 14 to 18 inches. The mean annual temperature is 47 to 52 degrees F. and the mean summer temperature is 68 to 73 degrees F. The frost-free period is 130 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Open a Syracuse spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Syracuse loamy fine sand, 0 to 2 percent slopes, map unit So in Davis-Weber Area, Utah.
- Official Series Description: Syracuse(revised 02/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Oxyaquic Calcixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.