Swantown soil
Wild-clay potential
Weak indication
Weak indication: no layer of Swantown shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Swantown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Swantown spot on the map
Rated from the USDA soil survey record for Swantown gravelly sandy loam, 0 to 8 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 38 in (96 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2 A very gravelly loam layer about 5 to 13 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A very gravelly sandy loam layer about 13 to 22 in down: about 8% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerH4best layer A very gravelly sandy loam layer about 22 to 60 in down: about 8% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (H4), 22 to 60 in down in the typical profile: gray (10YR 5/1), light gray (10YR 7/1) dry. Raw colour is not fired colour.
About the soil
- Parent material: till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Jefferson County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington. Series is of small extent.
USDA, geographic setting: Swantown soils are on till plains at elevations from near sea level to about 600 feet. The soil formed in ablation till underlain by compact basal till. These soils are in a mild marine climate. The average precipitation ranges from 18 to 35 inches. The mean January temperature is 39 degrees F.; the mean July temperature is 59 degrees F.; and the mean annual temperature is about 50 degrees F. The growing season is about 220 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Quilcene: Strong lead
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Ahl: Weak indication
- Alderwood: Weak indication
- Beausite: Weak indication
- Belfast: Weak indication
See it on the map
Open a Swantown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Swantown gravelly sandy loam, 0 to 8 percent slopes, map unit StB in Jefferson County Area, Washington.
- Official Series Description: Swantown(revised 01/2000), established.
- Taxonomic class: Loamy-skeletal, isotic, acid, mesic Typic Petraquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.