Ahl soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ahl shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ahl soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ahl very gravelly loam, 50 to 70 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Lowers the potential High rock content (about 43% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A very gravelly loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly loam layer about 3 to 30 in down: about 10% clay, low plasticity when wet, dark red when moist. Weak indication
- BedrockH3 Unweathered bedrock about 30 to 34 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 3 to 30 in down in the typical profile: dark red (2.5YR 3/6), reddish brown (2.5YR 5/4) dry; soft, very friable, slightly sticky, plastic; smeary. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum from basalt.
- USDA family particle-size class: medial-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Jefferson County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington. Series is of small extent.
USDA, geographic setting: Ahl soils occur on steep to very steep mountainous topography at elevations of 800 to about 3,000 feet. These soils formed in colluvial material from basalt. They occur in a mild, cool marine climate having an annual precipitation of 50 to 100 inches, most of which falls as rain during the fall, winter, and spring months; mean annual temperature is about 49 degrees F.; the average summer temperature is about 60 degrees F.; the average winter temperature is about 36 degrees F.; and the frost-free period is 160 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Quilcene: Strong lead
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Alderwood: Weak indication
- Beausite: Weak indication
- Belfast: Weak indication
- Carlsborg: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ahl very gravelly loam, 50 to 70 percent slopes, map unit AhF in Jefferson County Area, Washington.
- Official Series Description: Ahl(revised 09/2004), established.
- Taxonomic class: Medial-skeletal, mixed, mesic Typic Haploxerands
- Rated with rule version 2026-09-28.1; the method is on the About page.