Stingal soil
Wild-clay potential
Weak indication
Weak indication: no layer of Stingal shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Stingal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Stingal spot on the map
Rated from the USDA soil survey record for Stingal loam, 1 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Lowers the potential Typically starts about 48 in (122 cm) down, deeper than most hand digging.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 20% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A loam layer about 0 to 2 in down: about 14% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH2 A loam layer about 2 to 6 in down: about 14% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH3 A loam layer about 6 to 13 in down: about 13% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH4 A loam layer about 13 to 25 in down: about 13% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH5 A loam layer about 25 to 48 in down: about 13% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH6best layer A very fine sandy loam layer about 48 to 74 in down: about 5% clay, low plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The sandy layer (H6), 48 to 74 in down in the typical profile: pale yellow (2.5Y 8/2), light brownish gray (2.5Y 6/2) moist; slightly hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits derived from limestone and sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Stingal soils are on low-level and intermediate-level lake terraces that are somewhat undulating or dissected in places. These soils formed in lacustrine deposits derived from calcareous sedimentary rocks such as limestone and sandstone. In places these deposits have been reworked by wind. Slopes are 1 to 10 percent. Elevations range from 4,300 to 5,200 feet. The climate is dry, subhumid with cool, moist winters and warm, dry summers. The mean annual temperature is 47 to 51 degrees F. and the average summer temperature is about 70 degrees F. The mean annual precipitation is 12 to 14 inches. The frost-free period is 100 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Stingal spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Stingal loam, 1 to 6 percent slopes, map unit SvB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Stingal(revised 04/2005), established.
- Taxonomic class: Coarse-silty, mixed, active, mesic Sodic Calcixerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.