Stetson soil
Wild-clay potential
Weak indication
Weak indication: no layer of Stetson shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Stetson soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Stetson spot on the map
Rated from the USDA soil survey record for Stetson gravelly fine sandy loam, 0 to 5 percent slopes (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 38 in (96 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly fine sandy loam layer about 0 to 7 in down: about 7% clay, low plasticity when wet, yellowish red when moist. Weak indication
- Sandy layerH2 A very gravelly sandy loam layer about 7 to 21 in down: about 5% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerH3 A very gravelly loamy sand layer about 21 to 27 in down: about 2% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH4best layer A very gravelly coarse sand layer about 27 to 65 in down: about 1% clay, low plasticity when wet, intermingled dark olive gray when moist. Weak indication
What it looks like raw
The sandy layer (H4), 27 to 65 in down in the typical profile: intermingled dark olive gray (5Y 3/2), and olive (5Y 5/3); loose. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly glaciofluvial deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Maine, Vermont, in these survey areas: Addison County, Vermont; Somerset County, Maine, Southern Part.
By state: wild clay in Maine,wild clay in Vermont.
USDA, distribution and extent: Maine, New Hampshire, and Vermont (MLRAs, 142, 143, 144B and 146). The series is of moderate extent.
USDA, geographic setting: Stetson soils are on glacial outwash plains, terraces, kames and eskers. Slope ranges from 0 to 60 percent. The soils formed in sand and gravel derived mainly from slate, shale and phyllite, with lesser amounts of gneiss, granite and limestone. The climate is humid and cool temperate. Mean annual precipitation ranges from 34 to 46 inches, and the mean annual temperature ranges from 38 to 46 degrees F. The frost-free season ranges from 90 to 140 days. Elevation ranges from 5 to 2000 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Melrose: Strong lead
- Biddeford: Strong lead
- Buxton: Strong lead
- Covington: Strong lead
- Lamoine: Strong lead
- Livingston: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
See it on the map
Open a Stetson spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Stetson gravelly fine sandy loam, 0 to 5 percent slopes, map unit StA in Addison County, Vermont.
- Official Series Description: Stetson(revised 02/2000), established.
- Taxonomic class: Sandy-skeletal, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.