Shawmount soil
Wild-clay potential
Weak indication
Weak indication: no layer of Shawmount shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shawmount soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Shawmount spot on the map
Rated from the USDA soil survey record for Shawmount-Ada complex, 5 to 25 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (16).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 55% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A gravelly sandy loam layer about 0 to 3 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAB A gravelly sandy loam layer about 3 to 10 in down: about 19% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1 A very gravelly sandy clay loam layer about 10 to 16 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt2 A very gravelly sandy clay loam layer about 16 to 26 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt3best layer A very gravelly sandy clay loam layer about 26 to 38 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerE and Bt A stratified extremely gravelly sandy loam to sandy clay loam layer about 38 to 48 in down: about 18% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerC An extremely gravelly coarse sandy loam layer about 48 to 60 in down: about 14% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 26 to 38 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central and southwestern Idaho. MLRA 10 and 11. Shawmount soils are not extensive.
USDA, geographic setting: Shawmount soils are nearly level to very steep on flood-plain steps, stream terraces, relict lakebed escarpments and eroded fan remnants at elevations of 2,500 to 4,000 feet. Slopes range from 1 to 65 percent. These soils formed in alluvium and colluvium from igneous rocks (dominantly granitic). Average annual precipitation ranges from 13 to 16 inches. Average annual temperature ranges from 48 to 51 degrees F. Frost-free period is 130 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Shawmount spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shawmount-Ada complex, 5 to 25 percent slopes, map unit 3059 in Ada County, Idaho.
- Official Series Description: Shawmount(revised 06/2006), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Aridic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.