Sharptown soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 23 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sharptown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sharptown spot on the map
Rated from the USDA soil survey record for Sharptown silt loam, 2 to 5 percent slopes (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 15 in (39 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A silt loam layer about 10 to 20 in down: about 24% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Clay subsoilBt2 A silt loam layer about 20 to 23 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt3best layer A silt loam layer about 23 to 38 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerBC A loam layer about 38 to 44 in down: about 20% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Sandy layer2C1 A sandy loam layer about 44 to 46 in down: about 15% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
- Loamy layer2C2 A silt loam layer about 46 to 50 in down: about 25% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layer2C3 A loam layer about 50 to 58 in down: about 20% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Loamy layer2C4 A silt loam layer about 58 to 72 in down: about 25% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 23 to 38 in down in the typical profile: brown (7.5YR 5/4); silt loam; friable; slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty eolian deposits over glauconitic loamy marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New Jersey, in these survey areas: Salem County, New Jersey.
By state: wild clay in New Jersey.
USDA, geographic setting: Landscape: Coastal Plain uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Adelphia: Possible
- Mannington: Possible
- Mattapex: Possible
- Othello: Possible
- Sassafras: Possible
- Swedesboro: Possible
- Woodstown: Possible
- Chicone: Weak indication
See it on the map
Open a Sharptown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sharptown silt loam, 2 to 5 percent slopes, map unit ShnB in Salem County, New Jersey.
- Official Series Description: Sharptown(revised 11/2002), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.