Shabliss soil
Wild-clay potential
Weak indication
Weak indication: no layer of Shabliss shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shabliss soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Shabliss spot on the map
Rated from the USDA soil survey record for Shabliss very fine sandy loam, 0 to 2 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 33 in (83 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 9% by volume).
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA A very fine sandy loam layer about 0 to 5 in down: about 8% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBw A silt loam layer about 5 to 17 in down: about 25% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Bkqm A cemented material layer about 17 to 27 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerCbest layer A fine sandy loam layer about 27 to 60 in down: about 8% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 27 to 60 in down in the typical profile: very pale brown (10YR 7/3), brown (10YR 5/3) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Northern Nevada, southwestern Idaho, and western Utah. These soils are extensive with about 232,000 acres of the series mapped to date. The series concept is in MLRA 24, the main acreage is in adjacent MLRA 28B, and other acreage occurs in MLRAs 11, 25, and 28A.
USDA, geographic setting: Shabliss soils are on fan aprons, partial ballenas, and fan remnants. These soils formed in alluvium derived from mixed rocks with a thin loess mantle high in volcanic ash. Slopes are 0 to 50 percent. Elevations range from 825 to 2,260 meters. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 250 mm, the mean annual temperature is 6 to 12 degrees C, and the frost-free period is 100 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Shabliss spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shabliss very fine sandy loam, 0 to 2 percent slopes, map unit 172 in Ada County, Idaho.
- Official Series Description: Shabliss(revised 03/2016), established.
- Taxonomic class: Loamy, mixed, superactive, mesic, shallow Xereptic Haplodurids
- Rated with rule version 2026-09-28.1; the method is on the About page.