Sanpete soil
Wild-clay potential
Weak indication
Weak indication: no layer of Sanpete shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sanpete soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sanpete spot on the map
Rated from the USDA soil survey record for Sanpete gravelly silt loam, high rainfall, 1 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 80% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 55% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A gravelly silt loam layer about 0 to 5 in down: about 14% clay, low plasticity when wet, pale brown when moist. Weak indication
- TopsoilA1 A gravelly silt loam layer about 5 to 10 in down: about 14% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerB2 A very gravelly loam layer about 10 to 19 in down: about 14% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerC1ca An extremely gravelly sandy loam layer about 19 to 31 in down: about 14% clay, low plasticity when wet, light brown when moist. Weak indication
- Sandy layerC2ca,C3best layer An extremely gravelly silt loam layer about 31 to 56 in down: about 14% clay, low plasticity when wet, light brown when moist. Weak indication
- Sandy layerC4 An extremely gravelly loam layer about 56 to 65 in down: about 14% clay, low plasticity when wet, light brown when moist. Weak indication
What it looks like raw
The sandy layer (C2ca,C3), 31 to 56 in down in the typical profile: light brown (7.5YR 6/3), brown (7.5YR 5/3) moist; soft, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium, colluvium, and lacustrine deposits derived from limestone.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Central and northern Utah. MLRA 28A. This series is moderately extensive.
USDA, geographic setting: Sanpete soils occur on alluvial fans, alluvial flats, foothills, ballenas, fan remnants, fan skirts and inset fans. Slope range is 1 to 60 percent. These soils formed in alluvium derived from limestone, sandstone, shale, and igneous rock. These soils occur at elevations of 1,520 to 2,180 meters. The climate is semiarid to dry subhumid with a mean annual air temperature of about 7 to 11 degrees C., mean summer temperature of about 18 to 20 degrees C. and average annual precipitation is about 200 to 300 mm. The freeze-free period ranges from 100 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Sanpete spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sanpete gravelly silt loam, high rainfall, 1 to 6 percent slopes, map unit SlB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Sanpete(revised 03/2010), established.
- Taxonomic class: Loamy-skeletal, carbonatic, mesic Xeric Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.