Sandall soil
Wild-clay potential
Weak indication
Weak indication: no layer of Sandall shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sandall soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sandall spot on the map
Rated from the USDA soil survey record for Sandall cobbly silt loam, 30 to 60 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 49% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 50% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A cobbly silt loam layer about 0 to 2 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- TopsoilA12 A cobbly silt loam layer about 2 to 7 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB2 A gravelly loam layer about 7 to 16 in down: about 24% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Loamy layerC1ca A very cobbly loam layer about 16 to 24 in down: about 24% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerC2cabest layer A very cobbly loam layer about 24 to 35 in down: about 24% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- BedrockR Unweathered bedrock about 35 to 45 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (C2ca), 24 to 35 in down in the typical profile: very pale brown (10YR 8/2), light gray (10YR 7/2) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum derived from limestone, sandstone, and quartrzite.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah and south-central Idaho. These soils are moderately extensive. The series concept and main acreage is in MLRA 28A, while other acreage occurs in MLRA 13.
USDA, geographic setting: Sandall soils are on mountains, hills, and ridges. They usually occur on south and west-facing backslope and footslope positions. These soils formed in colluvium over residuum derived mainly from limestone with some sandstone and quartzite. Some areas are locally influenced by loess. Slopes are 3 to 60 percent. Elevations range from 4,300 to 6,800 feet. The mean annual precipitation is 11 to 14 inches, the mean annual temperature is 46 to 54 degrees F., and the frost-free period is 80 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Sandall spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sandall cobbly silt loam, 30 to 60 percent slopes, map unit SEG in Box Elder County, Utah, Eastern Part.
- Official Series Description: Sandall(revised 05/2005), established.
- Taxonomic class: Loamy-skeletal, carbonatic, mesic Xeric Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.