Salmon soil
Wild-clay potential
Weak indication
Weak indication: no layer of Salmon shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Salmon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Salmon very fine sandy loam, 0 to 3 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerH1 A very fine sandy loam layer about 2 to 24 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH2 A very fine sandy loam layer about 24 to 36 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH3best layer A loamy very fine sand layer about 36 to 65 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 36 to 65 in down in the typical profile: grayish brown (2.5Y 5/2). Raw colour is not fired colour.
About the soil
- Parent material: lacustrine.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 11 map units in New Hampshire, Vermont, in these survey areas: Addison County, Vermont; Coos County Area, New Hampshire; Washington County, Vermont.
By state: wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: MLRAs 142, 143, 144B, and 146 in the northern borders and local areas in the interior of the Adirondack highlands of New York and in Maine, New Hampshire, and Vermont. The series is moderately extensive.
USDA, geographic setting: Salmon soils are nearly level to steep on convex or planar landscapes. They formed in wind or water-deposited, acid material dominated by silt and very fine sand. These soils are on lake plains and in some upland areas. Slope ranges from 0 to 50 percent. Mean annual precipitation ranges from 711 to 1219 mm (28 to 48 in); mean annual air temperature ranges from 5 to 7 degrees C (41 to 46 degrees F); and the frost-free growing season ranges from 90 to 160 days. The elevation range is 152 to 457 m (500 to 1500 ft).
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Covington: Strong lead
- Lamoine: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Salmon very fine sandy loam, 0 to 3 percent slopes, map unit 630A in Coos County Area, New Hampshire.
- Official Series Description: Salmon(revised 02/2017), established.
- Taxonomic class: Coarse-silty, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.