Rumney soil
Wild-clay potential
Weak indication
Weak indication: no layer of Rumney shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Rumney soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Rumney fine sandy loam, 0 to 3 percent slopes, frequently flooded (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 9 in down: about 7% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerBg1 A fine sandy loam layer about 9 to 20 in down: about 4% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBg2 A sandy loam layer about 20 to 30 in down: about 2% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerCgbest layer A loamy sand layer about 30 to 65 in down: about 1% clay, low plasticity when wet, olive gray when moist. Weak indication
What it looks like raw
The sandy layer (Cg), 30 to 65 in down in the typical profile: olive gray (5Y 4/2); loamy sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium derived from schist and/or coarse-loamy alluvium derived from quartzite and/or coarse-loamy alluvium derived from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in New Hampshire, Vermont, in these survey areas: Coos County Area, New Hampshire; Washington County, Vermont.
By state: wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: Maine, northern Connecticut, Massachusetts, New Hampshire, Vermont, and eastern and northern New York; MLRA 101*, 141, 142, 143 144A, 144B, 145*, and 146. The series is of moderate extent.
USDA, geographic setting: Rumney soils are on the floodplains of rivers and streams. Slope ranges from 0 to 3 percent. The soils formed in recent alluvium derived principally from gneiss, schist, granite, and quartzite. Flooding generally occurs once or twice annually, but may occur less often than once in 2 years in some places. Overflow generally occurs during spring runoff and during periods of high rainfall. The climate is humid and cool temperate. Mean annual precipitation ranges from 34 to 50 inches, and mean annual temperature ranges from 38 to 46 degrees F. The frost-free season ranges from 80 to 160 days. Elevation ranges from 10 to 2000 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Adams: Weak indication
- Berkshire: Weak indication
- Colton: Weak indication
- Grange: Weak indication
- Hogback: Weak indication
- Nicholville: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 84%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Rumney fine sandy loam, 0 to 3 percent slopes, frequently flooded, map unit 105A in Coos County Area, New Hampshire.
- Official Series Description: Rumney(revised 04/2013), established.
- Taxonomic class: Coarse-loamy, mixed, active, nonacid, frigid Fluvaquentic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.