Roshe Springs soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 27 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Roshe Springs soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Roshe Springs spot on the map
Rated from the USDA soil survey record for Roshe Springs silt loam, 0 to 3 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note Thick enough to investigate (about 33 in (83 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 60% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, gray when moist. Weak indication
- TopsoilA1 A silt loam layer about 10 to 20 in down: about 23% clay, moderate plasticity when wet, gray when moist. Weak indication
- Loamy layerC1ca A silt loam layer about 20 to 27 in down: about 23% clay, moderate plasticity when wet, gray when moist. Possible
- Loamy layerC2gbest layer A silt loam layer about 27 to 60 in down: about 23% clay, moderate plasticity when wet, light gray when moist. Possible
What it looks like raw
The loamy layer (C2g), 27 to 60 in down in the typical profile: light gray (N 7/0), gray (5Y 5/1) moist; hard, very friable. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Roshe Springs soils are on low lake terraces and flood plains. These soils formed in alluvium and lacustrine deposits derived dominantly from limestone, quartzite, sandstone, and gneiss. Slopes are 0 to 3 percent. Elevation ranges from 4,200 to 5,100 feet. The climate is dry subhumid. The mean annual precipitation is 12 to 18 inches, the mean annual temperature is 45 to 54 degrees F., and the frost-free period is 100 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Open a Roshe Springs spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Roshe Springs silt loam, 0 to 3 percent slopes, map unit Ru in Box Elder County, Utah, Eastern Part.
- Official Series Description: Roshe Springs(revised 04/2006), established.
- Taxonomic class: Fine-loamy, carbonatic, mesic Typic Calciaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.