Ridgebury soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ridgebury shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ridgebury soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ridgebury spot on the map
Rated from the USDA soil survey record for Ridgebury fine sandy loam (Kennebec County, Maine) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 51 in (129 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 8 in down: about 7% clay, low plasticity when wet, black when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 8 to 14 in down: about 7% clay, low plasticity when wet, dark gray when moist. Weak indication
- Sandy layerH3best layer A fine sandy loam layer about 14 to 65 in down: about 7% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 14 to 65 in down in the typical profile: gray (5Y 5/1); firm. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy lodgment till derived from mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maine, in these survey areas: Kennebec County, Maine.
By state: wild clay in Maine.
USDA, distribution and extent: Glaciated landforms in Connecticut, Massachusetts, New Hampshire, New Jersey, New York, and Rhode Island. (MLRAs 142, 144A, 145, and 149B) The series is extensive.
USDA, geographic setting: The nearly level to gently sloping Ridgebury soils are in depressions and drainageways of till uplands. They also occur in toeslope positions and concave microfeatures of hills, drumlins, and ground moraines, and in till plains. Slope ranges from 0 to 15 percent. The soils formed in loamy lodgment till derived mainly from granite, gneiss and schist. Mean annual air temperature ranges from 7 to 11 degrees C and mean annual precipitation ranges from 1016 to 1270 mm. Mean growing season ranges from 100 to 195 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Biddeford: Strong lead
- Buxton: Strong lead
- Lamoine: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Berkshire: Weak indication
- Charles: Weak indication
- Deerfield: Weak indication
See it on the map
Open a Ridgebury spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 87%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ridgebury fine sandy loam, map unit RcA in Kennebec County, Maine.
- Official Series Description: Ridgebury(revised 03/2015), established.
- Taxonomic class: Loamy, mixed, superactive, acid, mesic, shallow Aeric Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.