Richville soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 12 to 18 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Richville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Richville spot on the map
Rated from the USDA soil survey record for Richville gravelly loam, 30 to 60 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 6 in (16 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note USDA reports about 28% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A gravelly loam layer about 0 to 4 in down: about 21% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerB2 A gravelly clay loam layer about 4 to 12 in down: about 30% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerC1kbest layer A clay loam layer about 12 to 18 in down: about 30% clay, moderate plasticity when wet, brown when moist. Promising
- Loamy layerC2k A loam layer about 18 to 28 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- BedrockC3r, IIC4r Weathered bedrock about 28 to 39 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (C1k), 12 to 18 in down in the typical profile: brown (7.5YR 5/4), light brown (7.5YR 6/4) dry; hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum derived from tuffaceous sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 28 in (71 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern UTAH . This series is inextensive.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Richville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Richville gravelly loam, 30 to 60 percent slopes, map unit RvG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Richville(revised 03/1999), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Typic Calcixerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.