Richens soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 24 to 56 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Richens soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Richens spot on the map
Rated from the USDA soil survey record for Richens loam, 3 to 15 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA11 A loam layer about 0 to 8 in down: about 24% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA12 A loam layer about 8 to 17 in down: about 24% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA2 A very cobbly silt loam layer about 17 to 19 in down: about 24% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- Clay-rich layerB21t A gravelly silty clay layer about 19 to 24 in down: about 45% clay, high plasticity when wet, yellowish red when moist. Possible
- Clay-rich layerB22t, B23tbest layer A clay layer about 24 to 56 in down: about 45% clay, high plasticity when wet, red when moist. Strong lead
- BedrockCr Weathered bedrock about 56 to 68 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (B22t, B23t), 24 to 56 in down in the typical profile: red (2.5YR 5/8), red (2.5YR 5/6) dry; extremely hard, extremely firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and/or slope alluvium over residuum weathered from conglomerate.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Lithic bedrock typically about 56 in (142 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is inextensive. About 6,500 acres are mapped.
USDA, geographic setting: Richens soils are at elevations of 7,000 to 8,700 feet. They occur on rolling mountain tops. Slopes range from 3 to 60 percent. These soils formed in glacial till weathered from conglomerate of sandstone and quartzite over residuum weathered from sandstone. The climate is humid, and the average annual precipitation ranges from 24 to 35 inches. The mean annual temperature is 31 to 42 degrees F. The mean summer temperature is 53 to 55 degrees F., and the freeze-free period ranges from 40 to 65 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Richens spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Richens loam, 3 to 15 percent slopes, map unit RhC in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Richens(revised 02/1999), established.
- Taxonomic class: Fine, smectitic Pachic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.