Redcan soil
Wild-clay potential
Weak indication
Weak indication: no layer of Redcan shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Redcan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Redcan-Rock outcrop complex, 40 to 60 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (7.5).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (35 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 28% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1, C1 A cobbly loam layer about 0 to 5 in down: about 23% clay, moderate plasticity when wet, dark red when moist. Weak indication
- Loamy layerC2best layer A very gravelly clay loam layer about 5 to 19 in down: about 31% clay, moderate plasticity when wet, red when moist. Weak indication
- BedrockC3r Weathered bedrock about 19 to 23 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (C2), 5 to 19 in down in the typical profile: red (2.5YR 4/6), red (2.5YR 5/6) dry; hard, firm, slightly sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum derived from sandstone and shale.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Paralithic bedrock typically about 19 in (48 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is inextensive.
USDA, geographic setting: Redcan soils are at elevations of 6,000 to 7,000 feet. They occur on south and west facing mountain slopes. Slopes range from 40 to 60 percent. These soils formed in residuum and local alluvium weathered from shale and calcareous sandstone. The climate is moist subhumid, and the average annual precipitation ranges from 18 to 20 inches. The mean annual temperature is 39 to 43 degrees F. The mean summer temperature is 59 to 63 degrees F., and the frost free period ranges from 75 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Redcan-Rock outcrop complex, 40 to 60 percent slopes, map unit RcG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Redcan(revised 03/2003), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, calcareous, frigid, shallow Typic Xerorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.