Quailridge soil
Wild-clay potential
Weak indication
Weak indication: no layer of Quailridge shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Quailridge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Quailridge spot on the map
Rated from the USDA soil survey record for Quailridge-Fortbois complex, 35 to 90 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A loamy coarse sand layer about 0 to 4 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBt1 A sandy clay loam layer about 4 to 8 in down: about 21% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt2 A coarse sandy loam layer about 8 to 19 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerE and Btbest layer A stratified loamy coarse sand to sandy clay loam layer about 19 to 46 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerC A fine gravelly coarse sand layer about 46 to 60 in down: about 2% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (E and Bt), 19 to 46 in down in the typical profile: very pale brown (10YR 7/3), pale brown (10YR 6/3) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: sandy lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. MLRA 10. Quailridge soils are not extensive.
USDA, geographic setting: Quailridge soils are steep to very steep on hill backslopes and gulch slopes (dissected remnant basin-margin fluvial facies) at elevations of 2,700 to 3,850 feet. Slopes range from 25 to 65 percent. These soils formed in deltaic deposits from granitic rocks and volcaniclastic materials. Average annual precipitation is 12 to 16 inches. Average annual temperature is 50 to 52 degrees F. Frost-free period is 140 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Quailridge spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Quailridge-Fortbois complex, 35 to 90 percent slopes, map unit 3058 in Ada County, Idaho.
- Official Series Description: Quailridge(revised 07/2012), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aridic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.