Purdam soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 13 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Purdam soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Purdam silt loam, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 19% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Clay subsoilBtk A silty clay loam layer about 10 to 13 in down: about 29% clay, high plasticity when wet, pale brown when moist. Possible
- Loamy layerBkbest layer A silt loam layer about 13 to 24 in down: about 19% clay, moderate plasticity when wet, pale brown when moist. Possible
- Bkqm A cemented material layer about 24 to 38 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layer2C A stratified very gravelly sand to loam layer about 38 to 60 in down: about 10% clay, low plasticity when wet. Weak indication
What it looks like raw
The loamy layer (Bk), 13 to 24 in down in the typical profile: pale brown (10YR 6/3), dark grayish brown (10YR 4/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or lacustrine deposits and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 14 map units in Idaho, in these survey areas: Ada County, Idaho; Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern and south-central Idaho; MLRA 11. The soil is extensive.
USDA, geographic setting: Purdam soils are on plug domes (buttes), lava flow lobes and troughs on lava plains and shield volcanoes and on dissected terraces in valleys. Elevations are 2,000 to 5,000 feet. Slopes are commonly less than 8 percent, but range up to 30 percent. The soils formed in silty alluvium from loess and weathered volcanic ash over medium or moderately coarse-textured alluvium from igneous materials. The average annual precipitation is 8 to 12 inches, including up to 2 feet of snow. Average annual temperature is 45 to 54 degrees F. The frost-free season is 100 to 160 days. - terms used throughout MLRA 11 to identify the setting of this soil are quire varied although all equate to the same...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Purdam silt loam, 0 to 1 percent slopes, map unit PrA in Canyon Area, Idaho.
- Official Series Description: Purdam(revised 09/2003), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Haploxeralfic Argidurids
- Rated with rule version 2026-09-28.1; the method is on the About page.