Pringle soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pringle shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pringle soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pringle spot on the map
Rated from the USDA soil survey record for Pringle loam (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 11 in down: about 17% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- TopsoilA13 A stratified very fine sandy loam to silt loam layer about 11 to 19 in down: about 15% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerIIC1best layer A very gravelly sand layer about 19 to 45 in down: about 2% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerIIC2 An extremely gravelly sand layer about 45 to 60 in down: about 2% clay, low plasticity when wet, dark brown when moist. Weak indication
What it looks like raw
The sandy layer (IIC1), 19 to 45 in down in the typical profile: dark brown (10YR 4/3), brown (10YR 5/3) dry; loose. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from limestone, sandstone and quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over fragmental.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is not extensive.
USDA, geographic setting: Pringle soils are at elevations of 4,800 to 7,000 feet. They occur on flood plains and stream terraces and valley floors. Slopes range from 0 to 3 percent. These soils formed in alluvium derived from sandstone, quartzite, and limestone. The climate is moist subhumid and the average annual precipitation ranges from 16 to 22 inches. The mean annual temperature is 42 to 46 degrees F. The mean summer temperature is 63 to 66 degrees F., and the freeze-free period ranges from 70 to 105 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Pringle spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pringle loam, map unit PrA in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Pringle(revised 02/1999), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, superactive, frigid Fluvaquentic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.