Pleasant View soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pleasant View shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pleasant View soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pleasant View spot on the map
Rated from the USDA soil survey record for Pleasant View loam, 1 to 3 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Note Moderate engineering plasticity index (7.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 21 in (54 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 22% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilAp A loam layer about 0 to 4 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA12best layer A gravelly loam layer about 4 to 25 in down: about 14% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA13 A gravelly loam layer about 25 to 34 in down: about 14% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC1ca A gravelly sandy loam layer about 34 to 45 in down: about 14% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC1ca A gravelly sandy loam layer about 45 to 56 in down: about 14% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC3 A gravelly sandy loam layer about 56 to 67 in down: about 14% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The topsoil (A12), 4 to 25 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah and southern Idaho along western front of the Wasatch Mountains. The soil is of moderate extent.
USDA, geographic setting: Pleasant View soils are on alluvial fans and lake terraces. Slopes are 1 to 20 percent. These soils have formed in alluvium dominantly from gneiss, schist, shale, and argillite. The climate is dry subhumid. The mean annual temperature ranges from 48 to 52 F., the mean summer temperature ranges from 68 to 73 degrees F., and the freeze-free season from 150 to 175 days. The mean annual precipitation ranges from 17 to 20 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abbott: Strong lead
- Airport: Strong lead
- Eimarsh: Strong lead
- Kirkham: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
See it on the map
Open a Pleasant View spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pleasant View loam, 1 to 3 percent slopes, map unit PvB in Davis-Weber Area, Utah.
- Official Series Description: Pleasant View(revised 04/2004), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.