Pioneervil soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pioneervil shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pioneervil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pioneervil spot on the map
Rated from the USDA soil survey record for Pioneervil-Grimescreek complex, 0 to 3 percent slopes (Boise County Area, Idaho, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 40 in (102 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA1 A sandy loam layer about 1 to 6 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A fine gravelly sandy loam layer about 6 to 12 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A sandy loam layer about 12 to 19 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBw2 A fine gravelly sandy loam layer about 19 to 25 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBC A very fine sandy loam layer about 25 to 31 in down: about 12% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- TopsoilAb A sandy loam layer about 31 to 35 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerCbest layer A stratified fine sandy loam to fine gravelly coarse sand layer about 35 to 75 in down: about 5% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 35 to 75 in down in the typical profile: light yellowish brown (10YR 6/4), yellowish brown (10YR 5/4) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 44. Pioneervil soils are of small extent.
USDA, geographic setting: Pioneervil soils are on flood plains at elevations of 3,400 to 4,650 feet. Slopes range from 0 to 3 percent. These soils formed in stratified loamy and sandy alluvium from igneous rocks (dominantly granodiorite). The mean annual precipitation is 22 to 28 inches. The mean annual temperature is 42 to 45 degrees F. The frost-free period is 60 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Hellake: Promising
- Hillcreek: Promising
- Middlefork: Promising
- Brownlee: Possible
See it on the map
Open a Pioneervil spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pioneervil-Grimescreek complex, 0 to 3 percent slopes, map unit 420 in Boise County Area, Idaho, Western Part.
- Official Series Description: Pioneervil(revised 03/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Fluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.