Middlefork soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 32 to 47 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Middlefork soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Middlefork spot on the map
Rated from the USDA soil survey record for Middlefork-Zeb complex, 8 to 25 percent slopes (Boise County Area, Idaho, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA1 A loam layer about 1 to 4 in down: about 14% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 4 to 12 in down: about 16% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBA A loam layer about 12 to 15 in down: about 17% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoilBt1 A loam layer about 15 to 32 in down: about 22% clay, moderate plasticity when wet, pale brown when moist. Possible
- Clay subsoilBt2best layer A clay loam layer about 32 to 47 in down: about 30% clay, moderate plasticity when wet, pale brown when moist. Promising
- Clay subsoilBt3 A sandy clay loam layer about 47 to 61 in down: about 24% clay, moderate plasticity when wet, light gray when moist. Possible
What it looks like raw
The clay subsoil (Bt2), 32 to 47 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 43b and 44. Middlefork soils are of small extent.
USDA, geographic setting: Middlefork soils are strongly sloping to steep on dissected fan remnants and outwash terrace remnants at elevations of 3,050 to 5,250 feet. These soils formed in lacustrine sediments derived from igneous rocks and fine pyroclastic materials. Slopes range from 8 to 50 percent. Average annual precipitation is 20 to 30 inches. Average annual temperature is 42 to 45 degrees F. Frost-free period is 60 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Hellake: Promising
- Hillcreek: Promising
- Brownlee: Possible
- Riverpoint: Possible
See it on the map
Open a Middlefork spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Middlefork-Zeb complex, 8 to 25 percent slopes, map unit 417 in Boise County Area, Idaho, Western Part.
- Official Series Description: Middlefork(revised 06/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Ultic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.