Hellake soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 22 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hellake soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hellake spot on the map
Rated from the USDA soil survey record for Hellake loam, 8 to 25 percent slopes (Boise County Area, Idaho, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (35 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 3 in down: about 20% clay, moderate plasticity when wet, brown when moist. Weak indication
- TopsoilAB A loam layer about 3 to 10 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1 A clay loam layer about 10 to 22 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Clay subsoilBt2best layer A clay loam layer about 22 to 36 in down: about 30% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Clay subsoilBt3 A clay loam layer about 36 to 43 in down: about 32% clay, high plasticity when wet, light yellowish brown when moist. Promising
- Loamy layer2BC A very gravelly loam layer about 43 to 53 in down: about 23% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layer2C1 A very gravelly sandy loam layer about 53 to 60 in down: about 10% clay, low plasticity when wet, brownish yellow when moist. Weak indication
- Sandy layer2C2 An extremely gravelly loamy sand layer about 60 to 66 in down: about 5% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt2), 22 to 36 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy lacustrine deposits over gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 44 and 43. Hellake soils are of small extent.
USDA, geographic setting: Hellake soils are level to steep on relict lakebed terraces, dissected fan remnants and landslides at elevations of 3,000 to 4,750 feet. These soils formed in lacustrine sediments over alluvium from igneous rocks. . Slopes range from 0 to 35 percent. Average annual precipitation is 20 to 26 inches. Average annual temperature is 45 to 48 degrees F. Frost-free period is 90 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Hillcreek: Promising
- Middlefork: Promising
- Brownlee: Possible
- Riverpoint: Possible
See it on the map
Open a Hellake spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hellake loam, 8 to 25 percent slopes, map unit 407 in Boise County Area, Idaho, Western Part.
- Official Series Description: Hellake(revised 06/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Ultic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.