Pineyneck soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pineyneck shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pineyneck soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pineyneck spot on the map
Rated from the USDA soil survey record for Pineyneck-Greenbelt complex, 0 to 8 percent slopes (Delaware County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 11% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAp A loam layer about 0 to 10 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBE A silt loam layer about 10 to 14 in down: about 14% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt A silt loam layer about 14 to 29 in down: about 16% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layer2BCbest layer A fine sandy loam layer about 29 to 47 in down: about 11% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layer2C A loamy fine sand layer about 47 to 61 in down: about 6% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Topsoil3Ab A fine sandy loam layer about 61 to 70 in down: about 18% clay, moderate plasticity when wet, gray when moist. Weak indication
- Sandy layer4Cg A loam layer about 70 to 80 in down: about 14% clay, moderate plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (2BC), 29 to 47 in down in the typical profile: strong brown (7.5YR 5/6); fine sandy loam. Raw colour is not fired colour.
About the soil
- Parent material: loamy eolian deposits over fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Delaware, Pennsylvania, in these survey areas: Delaware County, Pennsylvania; New Castle County, Delaware.
By state: wild clay in Delaware,wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: Coastal Plain of Maryland and Delaware
USDA, geographic setting: MLRA(s) using this series: 153C, 153D
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Talleyville: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Glenelg: Promising
- Hatboro: Promising
- Broadkill: Promising
- Califon: Promising
See it on the map
Open a Pineyneck spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pineyneck-Greenbelt complex, 0 to 8 percent slopes, map unit PnB in Delaware County, Pennsylvania.
- Official Series Description: Pineyneck(revised 12/2012), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.