Pilchuck soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pilchuck shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pilchuck soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pilchuck spot on the map
Rated from the USDA soil survey record for Pilchuck fine sandy loam (Polk County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 55 in (139 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 7 in down: about 3% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Sandy layerH2best layer A loamy fine sand layer about 7 to 62 in down: about 3% clay, low plasticity when wet, black when moist. Weak indication
What it looks like raw
The sandy layer (H2), 7 to 62 in down in the typical profile: black (10YR 2/1), very dark gray (10YR 3/1) dry; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed recent alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: not used.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Polk County, Oregon; Yamhill County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Western Washington and Oregon; MLRA 2. The series is moderately extensive.
USDA, geographic setting: Pilchuck soils are on flood plains at elevations of about 10 to 800 feet. The soils formed in recent sandy and gravelly alluvium. Slopes are 0 to 8 percent. The average annual precipitation is 35 to 60 inches. The average January temperature is 37 degrees F., average July temperature is 62 degrees F., and average annual temperature is about 50 degrees F. The frost-free season is about 160 to 210 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- McBee: Strong lead
- Wapato: Promising
- Chehalis: Promising
- Camas: Weak indication
- Cloquato: Weak indication
- Newberg: Weak indication
- Alyan: Strong lead(same state)
- Bashaw: Strong lead(same state)
See it on the map
Open a Pilchuck spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pilchuck fine sandy loam, map unit 58 in Polk County, Oregon.
- Official Series Description: Pilchuck(revised 08/2006), established.
- Taxonomic class: Mixed, mesic Dystric Xeropsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.