Phoebe soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 46 to 52 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Phoebe soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Phoebe fine sandy loam, 0 to 3 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts about 46 in (117 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 12% clay, low plasticity when wet, dark gray when moist. Weak indication
- TopsoilA12 A fine sandy loam layer about 8 to 16 in down: about 12% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA13 A fine sandy loam layer about 16 to 19 in down: about 12% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerB21, B22 A fine sandy loam layer about 19 to 46 in down: about 12% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerC1best layer A silty clay loam layer about 46 to 52 in down: about 31% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- Sandy layerC2 A loamy fine sand layer about 52 to 57 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Loamy layerC3 A silty clay loam layer about 57 to 60 in down: about 31% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (C1), 46 to 52 in down in the typical profile: light yellowish brown (10YR 6/4), dark yellowish brown (10YR 4/4) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from limestone, sandstone and quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Eastern Washington; MLRA 44A. Series is of moderate extent.
USDA, geographic setting: Phoebe soils formed in glacial outwash on outwash plains and terraces. Elevation is 1,300 to 2,600 feet in Washington and 4,900 to 5,000 feet in Utah. Slopes are 0 to 65 percent. The climate is characterized by relatively dry summers and cool moist winters. The mean annual precipitation is 15 to 25 inches. The average January temperature is 28 degrees F. and the average July temperature is about 68 degrees F. The mean annual temperature is 46 to 50 degrees F. The frost-free period is 100 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Phoebe fine sandy loam, 0 to 3 percent slopes, map unit PhA in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Phoebe(revised 02/2011), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.