Perma soil
Wild-clay potential
Weak indication
Weak indication: no layer of Perma shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Perma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Perma stony loam, 2 to 12 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Lowers the potential High rock content (about 46% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A stony loam layer about 0 to 7 in down: about 14% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBwbest layer A very cobbly loam layer about 7 to 38 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBC An extremely gravelly loamy sand layer about 38 to 60 in down: about 8% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (Bw), 7 to 38 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; slightly hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Perma soils are of moderate extent in western and central Montana. MLRAs - 43A, 43B, 44A, 44B, 46 and 48A.
USDA, geographic setting: Landform - stream terraces, outwash terraces, outwash plains, inset fans, alluvial fans, fan remnants, eroded fan remnants, escarpments, moraines, hills and mountains
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Perma stony loam, 2 to 12 percent slopes, map unit 77 in Missoula County Area, Montana.
- Official Series Description: Perma(revised 11/2012), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Typic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.